GAS CANISTER SLEEVE
How I make a gas canister sleeve
I hope, It is helpful by this flowing steps.
Step 1: Make a Pattern for Leather and Cut
Only two types of patterns are needed.
One is a donut shape and the other is a rectangle.
Step 2: Cut Leather for Upper Parts in a Circle
I used a special tool.
Is called a Circle cutter.
It doesn’t matter if you cut it yourself.
Step 3: Edge Creasing on Leather / Prepare for Sewing
I used a divider.
Step 4: Punch
I used a divider to adjust the spacing.
Important : the number of holes in both patterns should be the same.
In my case, there were 45.
Step 5: X-stitcing on Leather
One line looked so weak that it sewed two lines at the same time.
Step 6: Joining the Top and Side Parts
Put the top and the bottom together.
Step 7: Cross Stitch From Beginning to End
Pay attention to the shape and spacing of the stitch.
Step 8: Done!
Simple props were created.
手工皮具 » 用十字缝线法，缝个汽灯罐套